In this blog I will show you how to make a huge joint out of strange ingredients.
The joint is meant to be lit up, but no ones mouth is big enough to smoke it. I made the joints below to decorate and lite my coffeeshop’s bar, real joints are being smoked under the led loaded king size… Many of my clients told me they would like one for their room or house. Here is how to make your own…
The base of the joint is a piece of plywood, pick any size you like, your choice. My joints are 115 cms long.
I wanted it to look like a joint that has been smoked on already, so I took measurements from the one I was smoking at the moment.
I measured where to put the led lamps and the big hinge in the lines of the joint.
After making sure everything would fit in I jigsawed the joint out of the plywood.
We never close the shop for renovations, but we try to keep the place accessable, so my workshop is on the side walk, the dust just blows away…
Next step: wiring the joint up, I placed to fittings in the bottom of the joint to lite the bar, and one fitting at the wide end to light the tip of the joint.
Ready to start rolling up now…
I used chicken wire for the shape of the cone, makes it firm enough and keeps the weight low.
After that, I hung it up, wide side down.
I used old newspapers and wallpaper glue to skin the joint up, it is a bit messy, but very effective, it took about ten minutes to do the job.
I left it to dry overnight, together with the tip, made out of chicken wire and paper too.
The first joint is up, all it needs now is a little white paint.
There you go, painted and plugged in, seems to work.
The two huge joints work fine, the bar is well lit and the tips are glowing. Next time I will make me a bigger one to hang above the cannabis counter…